Roland 600 Manual do Utilizador descarregar pdf (Página 43)



Click the [ ] button.

The mode for specifying the rescanning area is can-

celed.



Drag to verify the area to rescan.

The specied rescanning area is displayed as a three-dimen-

sional form.



Click the [ ] button.

The [Settings for Scanning] dialog box appears.



If necessary, change the scanning pitch, then click

[Scan].

Here, none of the settings except for the scanning pitch can

be changed. It is also not possible to set a dierent scanning

pitch for each area.

You can perform rescanning as many times as you like after basic scanning. Also, when you want to redo scanning after

checking the scanning results, you can go back to the previous state before rescanning by clicking the [

] button.

For detailed information on rescanning methods, refer to the online help for Dr. PICZA3.

When You Want to Respecify the Rescanning Area

Go back to step 2 on the previous page, then click anywhere on

the object to clear the specied area.

Setting the Scanning Pitch

When performing rescanning, make the setting for the scanning

pitch as ne as possible. This increases the number of scanning

points, enhancing the degree of completion. When little free

memory is available, it may be a good idea to use a narrow scan-

ning area and perform rescanning in several passes.

Specied rescanning area

This executes

rescanning.

These set scan-

ning pitch.

Rescanning

area

3-4 Finishing the Data

3. Creating 3D Data

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 63 64

Sem comentários

Roland 600 Manual do Utilizador Página 43