Roland XC-540MT Manual do Utilizador descarregar pdf (Página 157)

ent temperature of the installation location. Bring the

installed location to a temperature at which operation

is possible (15 to 32°C) and allow the machine to come

to room temperature, then turn on the power.

[SERVICE CALL xxxx]

An unrecoverable error occurred, or part

replacement that must be performed by a

service technician is required.

Note the number displayed, then switch o the sub

power. After you switch o the power, inform your

authorized Roland DG Corp. dealer of the number

that appeared on the display.

[SHEET TOO SMALL CONTINUE?]

The size of the data is larger than the printing

or cutting area of the loaded media.

To continue performing output without correcting

this, press . At this time, the portion extend-

ing beyond the printing or cutting area is not output.

To stop output, stop sending data from the computer,

then hold down for one second or longer.

Make the printing or cutting area wider, such as by

replacing the media with a larger piece of media or

by changing the positions of the pinch rollers, then

send the data again.

[SHEET SET ERROR SET AGAIN]

was pressed even though no media

is loaded.

Press any key to clear the error. Load media and pull

back the loading lever, then press .

[EDGE DETECTION] is set to "ENABLE," but

transparent media was loaded.

Raise the loading lever, set the [EDGE DETECTION]

menu item to "DISABLE," then reload the media.

 P. 94, "Using Transparent Media"

The loaded media is too small.

Press any key to clear the error. Replace with media

of usable size.

[HEAD HEIGHT ERROR]

The height-adjustment lever for the print

heads was operated improperly.

Operation cannot be continued. Switch the sub power

o, then back on. To change the head height, use the

[HEAD HEIGHT] menu.

 P. 93, "Adjusting Head Height to Match Media Thick-

ness"

[TEMPERATURE IS TOO LOW **°C]

The temperature of the location where the

machine is installed has fallen below the

ambient temperature at which the machine

can operate.

Operation cannot be continued. Switch o the sub

power. The displayed temperature is the current ambi-

ent temperature of the installation location. Bring the

installed location to a temperature at which operation

is possible (15 to 32°C) and allow the machine to come

to room temperature, then turn on the power.

[DATA ERROR CANCELING...]

Output was stopped because a problem was

found in the data received.

Operation cannot be continued. Check whether the

data contains errors. Also, check for a problem with

the connector cable or the computer, and redo the

operation from the step of loading the media.

[PINCHROLL ERROR LOWER PINCHROLL]

was pressed without rst lowering

the pinch rollers.

Press any key to clear the error. Pull back the loading

lever, then press .

The pinch rollers were raised while

was illuminated.

The error is cleared automatically after a short wait.

Never move the loading lever while printing is in

progress.

Chapter 6 Feature Reference

7-8 If an Error Message Apperars

Chapter 7 What to Do If

155

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 171 172

Comentários a estes Manuais

Sem comentários

Roland XC-540MT Manual do Utilizador Página 157

Comentários a estes Manuais

Manuais e produtos relacionados com Digitalizar e Imprimir Roland XC-540MT