Roland R-1000 Manual de Serviço descarregar pdf (Página 110)

Manual

Double Sheet Detector R1000 series E20

Start-up

B0046991 / Rev. 1.6

110

ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33

System parameter 4: Adjusting the measuring mode.

Fig.. 57: Adjusting the measuring mode

Possible measurement modes:

• External continuous measurement:

The system executes measurements, as long as the “Measurement start“ signal is applied

via the external PLC input. The repetition rate of the measurement depends on the type of

sensor: 0.5 seconds for P42, P30, P42A, P75V; 1 second for P36; 2 seconds for P75.

• External single measuring:

The system measures once if the “Measurement start“ signal is applied via the external PLC

input. Each measurement must initiated separately. The hints in chapter 6.1.4.1 „timing

diagram single measurement“ must be abided by.

• Demo mode:

This mode of operation is intended for equipment demonstrations, but not for normal process

operation. The system executes measurements continuously. The repetition rate of the

measurement depends on the type of sensor: 1 second for P42, P30, P42A, P75V;

2 seconds for P36; 4 seconds for P75.

System parameter 5: Adjusting the baud rate of the serial RS232 interface (for C version only).

Fig.. 58: Adjusting the baud rate

According to the requirements of the super-ordinated system, values from 300 – 19200 can be set.

System parameter 6: Deleting all measuring programs.

Fig.. 59: Deleting of measuring programs

Attention The deletion cannot be undone.

system param. 4

mode: ext.cont.

system param. 5

baud rate: 9600

system param. 6

CLR param.: no

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 135 136

Sem comentários

Roland R-1000 Manual de Serviço Página 110