Roland CX-400 Especificações descarregar pdf (Página 25)

5-2 Details of the Origin-point Location and Cutting Area

The Location of the Origin Point Immediately After Loading Material

With the CX-500/400/300, the initial origin point is determined when you load material and press the [ENTER] key. The origin point

that is initially determined when you press the [ENTER] key differs according to the selection made for [SELECT SHEET] with the

operation panel when loading material.

[ROLL] Set near the left-hand pinch roller

[PIECE] Material size is detected and the origin is set at the lower-left area of the material

[F-EDGE] Set at the front left edge of the material

[R-EDGE] Set at the inner left edge of the material (When using the “Front loading”)

For more information, see the following page.

* When [AXIS ROTATE] is set to [90deg], the initial origin point is set at the lower right with the X and Y axes rotated 90 degrees.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

Sem comentários

Roland CX-400 Especificações Página 25