Roland Metaza MPX-80 Manual do Utilizador descarregar pdf (Página 35)

Chapter 3 Performing Printing

3-5 Loading Material (Using the Center Vise)

Using the Center Vise

With the center vise, you secure material in place by clamping it in the vise. The act of securing material in place with

the vise always determines the center position of the material in the horizontal direction at the horizontal center

position of the machine’s table. For the vertical center position, you perform adjustment using the scale on the vise as

a guide.

You can also vary the orientation of the vise when using it. Use it in a way matched to the size and shape of the

material.

☞ P. 28, "Preparing Material to Print"

Correspondence Between the Center Vise Scale and the Table Scale

Vice

You can also install it with the front and back

reversed.

This is suitable for clamping plate-shaped material. This is suitable for clamping cylindrical material.

Table

(1 scale tick = 5 mm)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 95 96

Sem comentários

Roland Metaza MPX-80 Manual do Utilizador Página 35